 |
|||||||||
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
Cavity Weep
MTI Cavity Weep™ (#CV 5010): 2.25" (57 mm) wide weep legs at 9.5" (241 mm) on center; continuous belt 1" (25.4 mm) wide; and total width of 6" (152 mm).
Floor Edging
MTI Floor Edging™ (#FE 8555): 0.024" (0.6 mm) thick high-impact polystyrene strip formed with 3/16" (4.8 mm) deep corrugations, bent into L-shape, 9" (229 mm) wide by 5" (127 mm) high. The system shall form a control joint between slab and wall and serve as a thermal break..
Mortar Belt
Mortar Belt™(#MB 3550): 0.024" (0.6 mm) thick high impact polystyrene strip formed with 3/16" (4.8 mm) deep corrugations; 33/8" wide, 50'-0" (15 m) long continuous belt. System shall be designed to suspend and trap trash mortar occurring within the cells of CMU.
Twenty Year Warranty
MTI's products are all covered by a 20 year limited warranty. Click here for details.
MTI’s Single Wythe Wall System works because it weeps the wall at the bottom of the core, controls the trash mortar, and separates the edge of the concrete floor from the base of the wall. Any water that may accumulate in core of block or run down inside of wall will pass by edge of floor and not onto floor.
Cavity Weep™ Order Now!
Floor Edging™ Order Now!
Mortar Belt ™ Order Now!
MTI’s Single Wythe Wall System
It
has several
advantages over the traditional stepped base
flashing. It does not create a shear plane at the base
of the wall. It is well bonded to the foundation. The
structural engineer will be happy. It does not
interfere with placement of the rebar that the
structural engineer usually places in the center of
the wall. Since it uses typical block instead of two
half-sized units, you avoid the problem of getting an
off-color stripe at the flashing locations. (When blocks are manufactured at different times, you
often get slight variations in color.)
Cavity Weep™ CV 5010
Floor Edging™ FE 8555
Mortar Belt™ MB 3550